Search results for "fiber sensor"
showing 10 items of 12 documents
High Sensitivity Refractive Index Sensor Based on Highly Overcoupled Tapered Fiber Optic Couplers
2017
In this paper, a simple and compact fiber-optic sensor based on an overcoupled tapered fiber coupler is studied. The coupler is fabricated to be operated well beyond the initial coupling cycles, where the rapid exchange of energy between outputs ports enable the fabrication of a highly sensitive device. The suitability and sensitivity of the proposed scheme is demonstrated by measuring refractive index (RI) variations of sugar concentrations in water. The device presents a linear response in terms of power transmission or wavelength shift versus RI changes. The best achieved sensitivity is 0.442 units of normalized transmission per unit of sugar concentration, with a noise detection limit o…
Development and analysis of a model based on chirped fiber Bragg gratings employed for cracks characterization in materials
2018
In this work a model was developed that allows to understand the behavior of a chirped fiber Bragg grating for the detection and characterization of cracks in materials. In addition to the amplitude response, we show that the group delay of the grating provides useful information for the characterization of the crack. The position of the crack can be determined thanks to the linear chirp of the grating that fixes a correlation between the spatial position and both, the wavelength and the group delay. However, our analysis shows that this simple approach has a source of error, which can be overcome if a controllable external strain can be applied to the embedded grating, additional to the st…
Simultaneous measurement of temperature and strain in glass fiber/epoxy composites by embedded fiber optic sensors: I. Cure monitoring
2007
In this paper (Part I) the use of fiber optic sensors for real-time monitoring of the cure kinetics of GFRP composites is explored. The proposed sensing system allows the simultaneous measurement of both temperature and strain by monitoring the change in reflected wavelength from two coupled fiber Bragg grating (FBG) sensors that have been embedded into the composite laminate. Instrumented GFRP laminates with 12, 18 and 24 reinforcing plies, respectively, were prepared by means of the vacuum bagging technique. Samples were cured in a thermally controlled oven at 80 degrees C and 30 kPa for 240 min (isothermal stage) and then cooled down to ambient temperature by turning off the heating sour…
Optical frequency domain reflectometer distributed sensing using microstructured pure silica optical fibers under radiations
2016
International audience; We investigated the capability of micro-structured optical fibers to develop multi-functional, remotely-controlled, Optical Frequency Domain Reflectometry (OFDR) distributed fiber based sensors to monitor temperature in nuclear power plants or high energy physics facilities. As pure-silica-core fibers are amongst the most radiation resistant waveguides, we characterized the response of two fibers with the same microstructure, one possessing a core elaborated with F300 Heraeus rod representing the state-of-the art for such fiber technology and one innovative sample based on pure sol-gel silica. Our measurements reveal that the Xray radiations do not affect the capaci…
Radiation Characterization of Optical Frequency Domain Reflectometry Fiber-Based Distributed Sensors
2016
International audience; We studied the responses of fiber-basedtemperature and strain sensors related to Optical FrequencyDomain Reflectometry (OFDR) and exposed to high γ-ray dosesup to 10 MGy. Three different commercial fiber classes areused to investigate the evolution of OFDR parameters withdose, thermal treatment and fiber core/cladding composition.We find that the fiber coating is affected by both thermal andradiation treatments and this modification results in anevolution of the internal stress distribution inside the fiber that influences its temperature and strain Rayleigh coefficients. These two environmental parameters introduce a relative error up to 5% on temperature and strain…
Evaluation of Distributed OFDR-Based Sensing Performance in Mixed Neutron/Gamma Radiation Environments
2017
We report the study of a radiation resistant single mode optical fiber doped with fluorine exposed to mixed neutron and $\gamma $ -radiation up to $10^{17}$ n/cm2 fluence and >2 MGy dose to evaluate its performances when used as the sensing element of a distributed Optical Frequency Domain Reflectometry (OFDR). The use of complementary spectroscopic techniques highlights some differences between the responses of solely $\gamma $ -radiation (10 MGy) or mixed neutron and $\gamma $ ( $10^{17}$ n/cm $^{2}+>2$ MGy) irradiated samples. Those differences are linked to the defect generation rather than to structural changes of the ${a}$ -SiO2 host matrix. We show that a modification of the refracti…
Radiation Hardened Optical Frequency Domain Reflectometry Distributed Temperature Fiber-Based Sensors
2015
International audience; We study the performance of Optical Frequency Domain Reflectometry (OFDR) distributed temperature sensors using radiation resistant single-mode optical fibers. In situ experiments under 10 keV X-rays exposure up to 1 MGy( SiO 2 ) were carried out with an original setup that allows to investigate combined temperature and radiation effects on the sensors within a temperature range from 30 ° C to 250 ° C. Obtained results demonstrate that optical fiber sensors based on Rayleigh technique are almost unaffected by radiation up to the explored doses. We show that a pre-thermal treatment stabilize the sensor performance increasing the accuracy on temperature measurement fro…
Radiation Response of OFDR Distributed Sensors Based on Microstructured Pure Silica Optical Fibers
2015
International audience; Temperature sensors based on microstructured pure silica optical fibers are investigated by OFDR and RIA performed during X-ray irradiation up to 50kGy dose. The results evidence that the temperature measures are poorly influenced by irradiation (the error being less than 0.3°C). Such a radiation tolerance is relevant for the use of these Rayleigh based sensors in harsh environments.
High-speed and high-resolution interrogation of FBG sensors using wavelength-to-time mapping and Gaussian filters
2019
In this work we report a novel intensity-based technique for simultaneous high-speed and high-resolution interrogation of fiber Bragg grating (FBG) sensors. The method uses a couple of intensity Gaussian filters and the dispersion-induced wavelength-to-time mapping effect. The Bragg wavelength is retrieved by means of the amplitude comparison between the two filtered grating spectrums, which are mapped into a time-domain waveform. In this way, measurement distortions arising from residual power due to the grating sidelobes are completely avoided, and the wavelength measurement range is considerably extended with respect to the previously proposed schemes. We present the mathematical backgro…
Radiation Vulnerability of Fiber Bragg Gratings in Harsh Environments
2015
International audience; The difficulties encountered in the implementation of a temperature or strain sensor based on fiber Bragg grating (FBG) in a harsh radiative environment are introduced. We present the choices made to select both a radiation-resistant fiber in terms of transmission and also the grating inscription conditions necessary to write radiation tolerant FBGs in such fibers with a femtosecond laser. The radiation response of these gratings was also studied under radiation at dose up to 1 MGy. The comparison between Ge-free and Ge-doped fibers was highlighted.